@root42 If I could bother you with my restoration projects, I'd rather ask you to look into this broken 1541.
I replaced UD3 to fix an _RST signal that looked too low and too noisy, and now there's some CPU activity and very short LED blinks, suggesting a reset loop (it's not one of the diagnostic flash codes).
It's harder to see what's going on witth a computer lacking a screen and diagnostic cartridges... I'll try replacing both ROMs when I get the 27C64 adapter socket and the programmer.
@codewiz Did you go through the basics? Good power lines, clock signals?
What does the reset line say? Does it go low again, or just low, then high?
@root42 Power and clock looked good. Some IC output levels are more like 4V and look a bit noisy, but that's probably expected from MOS and TTL logic of this era.
Now RST and INT look good, and I see bus activity and CS being toggled on the ROMs. without an in-circuit emulator or a logic analyzer, I can't tell where the CPU is stuck.
My next move would be replacing the ROMs and maybe try a 6502 from a VIC20 to see if anything changes.
@codewiz so far I only ever saw ROMs fail on this side of a 1541. But who knows... I would also check all the chip select lines for the ROMs and VIAs. Those have to be working correctly to avoid bus conflicts. How does the data on address and data bus look?
@root42 All the signals on the bus look normal, except for D1 (pin 32 of the 6502), which looks like there's bus contention or something:
